TFI Lowering Blocks Holden HR - HZ 2'

Manufactured locally in Melbourne by National Auto Parts Depot

Suits:

- Mazda B2000 - Mazda B2500 - Mazda B2600 - Mazda E1600 - Mazda E2000 - Chrysler Valiant Charger VH VJ VK CL 1971-1978 - Chrysler Valiant RV1 SV1 AP5 AP6 VC 1960-1968 - Ford Courier PA 2WD 1978-1985 - Ford Econovan SA SD SB-SH (JG-JH Some) 1979-2006 - Ford Mustang 6 Cyl and V8 70mm Axle 1964-1970 - Holden HR HK HT HG 1967-1971 - Holden HQ HJ HX HZ WB Ute Van 1 Tonner 1972-1988 - Mitsubishi Galant GA GB GC GD 1971-1977 - Mitsubishi Lancer LA LB LC 1974-1984

Kit Contains:

- 2 Alloy Blocks Made of Billet 6063 Aluminium - Block Height 50mm - Block Width 58mm, Block Length 110mm - 4 x U Bolts : 75 x 12 mm - 8 x Serrated Nuts - Top Pin: 13 mm - Bottom Pin: 13 mm - 2 Year Replacement Warranty

Important Information:

Before you order please check:

Check differential housing that it uses "round U-bolts". We supply "round U-bolts" only.

Pin & U Bolt Size and compare to details above. If this differs from the size you require it is vital that you advise us what size you need and we will send you the link for the correct kit. Check clearance as suspension parts may hit fuel tank when vehicle is lowered. Please ensure that you have the clearance to lower your vehicle by the height specified before purchasing. Some vehicles may require drilling out of old mounting plates. Most kits have longer than standard U Bolts and will require cutting to size.